Dewalt Accessories DWAF2SQ1IR3 SQ1 Impact Bits 3 Pack

Product Description

The DEWALT ACCESSORIES DWAF2SQ1IR3 is a 3-piece set of Square 1 (SQ1) impact screwdriving bits sized at 2.25 inches, designed for licensed tradespeople and serious DIYers who rely on impact drivers and heavy-duty drills. Each bit features an engineered tip geometry that delivers a tighter, more precise fit on SQ1 fasteners, reducing cam-out and bit wear. The integrated FLEXTORQ Zone is built to flex under torsional load, absorbing impact energy rather than transferring it directly to the bit tip. This flex design extends service life significantly compared to standard solid-shank bits. Laser-etched size markings keep the bit identifiable even after extended field use.

This bit set is suited for residential and light commercial construction, finish carpentry, decking, and general fastening work where Square drive fasteners are standard. The 0.25-inch hex shank is impact-rated, making it fully compatible with impact drivers and standard drill-drivers. Electricians, carpenters, and general contractors will find these bits practical for high-cycle fastening tasks where bit longevity and consistent engagement are critical. The pack-of-three format is well suited to job-site kits where backups are routinely needed.

Key Features

• FLEXTORQ Zone absorbs torsional impact to extend bit service life versus conventional solid bits
• Engineered SQ1 tip geometry for improved fastener fit and reduced cam-out
• Laser-etched size identification remains readable through extended use
• 0.25-inch hex shank is impact-driver rated for use with cordless impact tools and drills
• Sold as a pack of 3 bits for job-site redundancy

Compatibility

Designed as an OEM-style impact-rated bit for use with any 0.25-inch hex chuck impact driver or drill-driver accepting standard 2.25-inch insert bits.

Installation Notes

Insert the bit fully into a 0.25-inch hex chuck before operating the tool. Inspect the bit tip for wear or rounding before each use, as a worn tip increases cam-out risk and can damage fastener heads. No power shutoff is required to swap bits, but ensure the tool trigger is locked out or the battery removed before changing bits by hand. Dispose of worn bits promptly to avoid field failures on structural fastening applications.