Dewalt Accessories DWAF2PH2IR3 PH2 Bits 2.25 in 3 Pack

Product Description

The DEWALT ACCESSORIES DWAF2PH2IR3 is a 3-pack of 2.25-inch Phillips PH2 impact screwdriving bits from the DEWALT FlexTorq 3.0 line. These bits are built around an overhauled tip geometry that improves fitment and reduces cam-out during high-torque fastening. Each bit includes a dedicated FlexTorq Zone engineered to absorb impact energy, which extends bit life compared to standard screwdriving bits. A laser-etched size marking on each bit makes identification fast in the field. Licensed electricians, plumbers, HVAC installers, and general trade contractors reach for these bits during any screw-drive application where an impact driver or drill is the primary tool.

These PH2 bits are suited for residential and light commercial fastening tasks. The 0.25-inch hex shank makes them compatible with standard impact drivers and drill-driver chucks. The FlexTorq 3.0 design is optimized for repetitive, high-volume screw driving where bit wear is a recurring cost. Packaged as a 3-piece set, they serve as a practical multi-bit supply for tool pouches, vehicle kits, or job site bags. Typical applications include drywall framing, panel work, equipment mounting, and general mechanical fastening.

Key Features

• FlexTorq Zone absorbs impact energy to extend bit life versus standard screwdriving bits
• Overhauled PH2 tip geometry improves fitment and reduces cam-out
• Impact-ready 0.25-inch hex shank fits impact drivers and standard drill chucks
• Laser-etched size markings for fast visual identification
• Delivers increased screw count per bit versus previous FlexTorq generation, on average
• Sold as a pack of 3 for job site redundancy

Compatibility

Designed for use in standard 0.25-inch hex shank impact drivers and drill-drivers. Suitable for Phillips PH2 fasteners in typical residential and light commercial trade applications.

Installation Notes

Insert the hex shank fully into the driver chuck or bit holder before operating. Confirm the fastener head matches PH2 geometry before driving to avoid tip wear and cam-out. Do not use worn or damaged bits, as reduced tip engagement increases the risk of fastener damage and slippage. No special tools or codes are required beyond the appropriate impact driver or drill.