Dewalt Accessories DW5209 Percussion Drill Bit 5/32x3 in

Product Description

The DEWALT ACCESSORIES DW5209 is a premium percussion drill bit designed for masonry and concrete drilling applications. The bit measures 5/32 inches in diameter and 3 inches in length. A 2-cutter carbide tip maximizes carbide surface contact, extending bit life during high-impact drilling. Four flutes channel debris out of the hole continuously, keeping the cut clean and maintaining drilling speed. Three flats machined into the shank prevent slipping in the chuck. This bit is sold in a 5-pack and is suited for use by contractors, electricians, plumbers, and other trades that regularly drill into masonry substrates.

This percussion drill bit is intended for use in rotary hammer and hammer drill applications where penetration into concrete, block, brick, or stone is required. It is a common tool on residential and light commercial job sites whenever anchor points, conduit runs, or pipe penetrations must be set into masonry. The 5/32-inch diameter is frequently used for setting smaller anchors and fasteners. The 5-pack format suits recurring use on production work where multiple holes are required.

Key Features

• 2-cutter carbide tip increases carbide surface contact for extended bit life under percussion loads
• Four-flute design evacuates debris from the bore for fast, efficient drilling
• Three flats on shank prevent bit rotation and slipping in the chuck
• 5/32-inch diameter by 3-inch length suits standard anchor and fastener applications in masonry
• Sold in a 5-pack for high-volume or repeat-use job site demand

Compatibility

Designed as a standard-shank percussion drill bit compatible with hammer drills and rotary hammers accepting 3-flat or round-shank bits in the 5/32-inch diameter range.

Installation Notes

Installation is performed by electricians, plumbers, HVAC technicians, and general contractors using a hammer drill or rotary hammer set to hammer-drill mode. Confirm the chuck accepts the 3-flat shank and secure the bit firmly before operation. Wear appropriate eye and respiratory protection when drilling masonry to guard against dust and spall. Do not use in rotary-only mode, as the bit is engineered for percussion drilling.