Dewalt Accessories DW2234IR Magnetic Nut Driver 1/2 in

Product Description

The DEWALT ACCESSORIES DW2234IR is a 1/2-inch impact-ready magnetic nut driver built for high-torque fastening in demanding trade environments. Sized at 1/2 inch by 2-9/16 inches, it fits standard impact drivers and handles up to 2,000 inch-pounds of torque without failure. The patented recessed-corner geometry drives on the flats of hex fasteners rather than the corners, reducing rounding and metal shavings. An advanced hardening process gives the driver extended service life under repeated impact loads. An extra-strength magnet retains fasteners securely during placement, speeding up repetitive fastening tasks on the job.

This nut driver is suited for residential and commercial applications where impact drivers are used to drive hex-head fasteners, sheet metal screws, and machine bolts. Electricians, HVAC technicians, plumbers, and general contractors reach for this driver when working with junction boxes, equipment panels, ductwork flanges, and structural hardware. The 2-9/16-inch length provides clearance in tight spaces without sacrificing reach. It is sold as a package of 3 units, making it practical for stocking service vans or job-site bags.

Key Features

• Impact-ready construction rated to 2,000 inch-pounds of torque
• Patented recessed-corner geometry drives on flats to reduce fastener rounding and metal shavings
• Advanced hardening process extends tool life under repeated impact loading
• Extra-strength magnet provides superior fastener retention during placement
• 1/2-inch drive size fits standard hex-head fasteners common in trade applications
• Packaged in a 3-piece set for job-site and van stock convenience

Compatibility

Designed for use with standard 1/4-inch hex shank impact drivers and drill-drivers that accept impact-rated accessories.

Installation Notes

This nut driver is installed by trade professionals using 1/4-inch hex shank impact drivers. Verify the driver is fully seated in the tool chuck before applying torque to prevent slipping. When working near energized electrical panels or equipment, de-energize and lock out the circuit per NFPA 70E requirements before using any fastening tool. Inspect the driver for wear or cracking regularly, and replace if deformation near the hex socket is observed.