Deltana ZHP70U15 Hinge Pin Door Stop Satin Nickel

Product Description

The DELTANA ZHP70U15 is a hinge-mounted hinge pin door stop made from zinc die-cast construction with a satin nickel finish. It installs directly onto an existing door hinge pin to limit how far a door swings open, protecting walls, baseboards, and adjacent fixtures from door handle impact. At 2.25 inches in length and 0.5 inches in height, this compact stop fits flush against the hinge without interfering with door operation. It is sold as a single unit and is suited for residential and light commercial interior door installations where a low-profile stop is preferred over floor or wall-mounted alternatives.

The ZHP70U15 is designed for standard interior hinged doors where wall or floor stops are impractical or undesirable. Typical applications include hallway doors, bedroom doors, and office doors where swing control is needed without visible hardware on the wall or floor. The satin nickel finish coordinates with commonly used door and hinge hardware in both residential and commercial settings. Installation requires no additional fasteners beyond the existing hinge pin, making it a straightforward swap during routine door hardware service or new construction finish work.

Key Features

• Hinge-mounted design installs on the existing hinge pin with no wall or floor drilling required
• Zinc die-cast construction provides solid, consistent form retention under repeated door contact
• Satin nickel finish blends with standard door hardware in residential and light commercial settings
• Low-profile at 0.5 inches height — minimal visual impact on door and frame
• Compact footprint at 2.25 inches long by 2 inches wide for use on standard door hinges
• Sold individually, allowing targeted replacement or single-door installation

Compatibility

Designed as an OEM-style hinge pin door stop for standard residential and light commercial hinged interior doors where hinge pin mounting is applicable.

Installation Notes

A licensed carpenter, finish hardware installer, or knowledgeable tradesperson can install this stop during door hardware service or new construction. Before installation, ensure the door is held open or supported to prevent unexpected movement while working on the hinge. The stop clips onto the hinge pin — remove the pin fully, seat the stop, and reinsert the pin per standard hinge service practice. Do not force the stop onto an incompatible pin diameter, as this may damage the zinc casting or the hinge.