Deltana FP222U15 Flush Pull Rectangle Satin Nickel

Product Description

The DELTANA FP222U15 is a rectangular flush pull designed for doors and cabinetry where a low-profile, surface-flush hardware solution is required. This pull sits recessed into the door face, eliminating any protruding handle that could catch on frames or adjacent surfaces. At 3.25 inches in length and 1.4 inches in width, it offers a clean, minimal footprint suited to sliding doors, pocket doors, and cabinet applications. The Satin Nickel finish provides a brushed, corrosion-resistant surface appropriate for both residential and light commercial installations. Finish carpenters, millwork installers, and general contractors are the primary trades that specify and install this type of hardware.

This flush pull is commonly used on pocket doors, barn-style sliding doors, bi-fold doors, and cabinet faces where a projecting pull is not practical or desired. The rectangular profile and Satin Nickel finish allow it to coordinate with contemporary and transitional hardware sets. It is sold individually and is appropriate for new construction as well as retrofit applications where existing hardware is being updated or replaced.

Key Features

• Low-profile rectangular design sits flush with door or cabinet surface
• Satin Nickel finish provides a brushed, corrosion-resistant appearance
• Compact dimensions of 3.25 inches x 1.4 inches x 0.5 inches depth
• Lightweight at 0.1 pounds, suitable for lightweight door and cabinet applications
• Sold individually, compatible with standard flush pull mortise preparations

Compatibility

Designed as an OEM-style flush pull for pocket doors, sliding doors, and cabinet faces requiring a recessed rectangular pull in a standard mortise cutout.

Installation Notes

Installation is typically performed by a finish carpenter or millwork installer. A mortise must be routed into the door or cabinet face to the appropriate depth before the pull is set and fastened. Ensure the mortise dimensions match the pull body before cutting. Follow applicable building codes and manufacturer fastener recommendations for the substrate material being used.