Dan-loc Bolt Gasket 130-04-060 Fully Threaded Stud

Product Description

The DAN-LOC BOLT GASKET 130-04-060 is a fully threaded stud machined from Grade 316 stainless steel to ASTM B8M standards. It features a 1/2-13 UNC thread form running the full 6-inch overall length with an uncoated finish. Fully threaded studs of this specification are used as fasteners in flanged connections, mechanical assemblies, and structural joints where double-nut or insert-plate installation is required. The Grade 316 material provides elevated corrosion resistance compared to Grade 304, making it a common choice in wet, chemical, or marine service environments.

This stud is suited for industrial, commercial, and mechanical trade applications where a continuous thread is needed along the entire fastener length. Typical uses include pipe flange bolting, HVAC equipment mounting, pump and valve assembly, and general structural fastening in corrosive or high-moisture environments. The 1/2-13 thread size is a standard coarse-thread designation compatible with 1/2-inch hex nuts and threaded inserts conforming to that specification.

Key Features

• Fully threaded along the entire 6-inch length for maximum engagement flexibility
• Grade 316 stainless steel construction for superior corrosion resistance in wet or chemical environments
• Meets ASTM B8M standard for stainless steel bolting materials
• 1/2-13 UNC coarse thread for compatibility with standard 1/2-inch hardware
• Uncoated finish - no plating to degrade or flake in service
• UNSPSC Code 31161618 for procurement system alignment

Compatibility

Designed as a standard fully threaded stud for use with 1/2-13 UNC nuts, couplers, and threaded inserts in mechanical, plumbing, and industrial fastening applications.

Installation Notes

Installation is typically performed by licensed plumbers, pipefitters, millwrights, or mechanical contractors. Always de-energize, depressurize, and isolate the system before disassembling any flanged or bolted connection. Use appropriately rated stainless steel nuts and washers to avoid galvanic incompatibility. Torque to the assembly specification provided by the equipment or flange manufacturer - do not estimate fastener torque.