Dan-loc Bolt Gasket 000-05-045 Fully Threaded Stud

Product Description

The DAN-LOC BOLT GASKET 000-05-045 is a fully threaded stud machined from B7 alloy steel with a 5/8-11 unified coarse thread and an overall length of 4.5 inches. It carries an uncoated plain finish, making it suitable for use as-installed or for field coating applications. Fully threaded studs like this one are used to secure flanged joints, structural assemblies, and mechanical connections where bolt-and-nut configurations are impractical. The B7 material grade indicates a chromium-molybdenum alloy steel with high tensile strength, appropriate for demanding mechanical and industrial fastening work.

This stud is suited for plumbing flange connections, HVAC equipment mounting, pressure vessel assemblies, and general industrial applications where a high-strength threaded fastener is required. The 5/8-11 thread is a standard coarse-pitch size widely used in trade and industrial settings. At 4.5 inches overall length, the stud accommodates typical flange stack heights with thread engagement on both ends. Plumbers, pipefitters, millwrights, and mechanical contractors commonly use this fastener type in flanged pipe and equipment installations.

Key Features

• 5/8-11 unified coarse thread for broad compatibility with standard nuts and tapped holes
• B7 alloy steel (chromium-molybdenum) construction for high tensile and yield strength
• Fully threaded along the entire 4.5-inch length for maximum engagement flexibility
• Uncoated finish suitable for field treatment or use in dry, controlled environments
• Sold individually, allowing single-unit procurement for repair and replacement work

Compatibility

Designed for use in flanged mechanical assemblies, pipe flange connections, and structural fastening applications requiring a 5/8-11 coarse-thread fully threaded stud in B7 alloy steel.

Installation Notes

Installation should be performed by a qualified plumber, pipefitter, or mechanical contractor following applicable codes and torque specifications for the assembly. Always de-energize, depressurize, and isolate the system before servicing any flanged connection. Use the appropriate nut and flat washer rated for the stud grade to avoid thread galling or fastener mismatch. Do not substitute with lower-grade hardware in high-pressure or high-temperature applications.