Crc 1005247 Rust Converter 1 Gallon Water-based

Product Description

The CRC 1005247 is a water-based rust converter supplied in a 1-gallon bottle. It chemically reacts with iron oxide on rusted metal surfaces, converting active rust into a stable, paintable base. The formulated compound contains a low VOC content of 11.20 grams per liter, making it suitable for use in areas where solvent-based products are restricted. Coverage reaches up to 500 square feet per gallon. The converted surface dries fully within 24 hours and is ready for recoat at the same interval. It is not food-grade rated. HVAC technicians, pipefitters, electricians, and general maintenance personnel apply this product to arrest rust progression before painting or coating metal components.

This rust converter is designed for use on a wide range of industrial and commercial metal surfaces. Typical applications include bridges, dumpsters, equipment frames, fences, chairs, overhead cranes, pipelines, railings, storage tanks, tables, trailers, transmission towers, and vehicles. It is well suited to field maintenance of HVAC equipment enclosures, rooftop unit curbs, condenser frames, electrical enclosures, and structural supports where surface rust has developed. The water-based formula allows application with standard brushes, rollers, or sprayers without the need for solvent-resistant equipment.

Key Features

• Converts active rust to a stable, paintable surface without mechanical removal
• Water-based formula with 11.20 g/L VOC content for low-emission compliance
• Covers up to 500 square feet per 1-gallon container
• Full dry time of 24 hours with recoat window also at 24 hours
• Supplied in a 1-gallon bottle for easy pouring and measured dispensing
• Meets OSHA standards for industrial maintenance use

Compatibility

Designed for use on ferrous metal surfaces exhibiting active rust, including structural steel, iron pipe, equipment housings, and fabricated metal assemblies across industrial, commercial, and utility maintenance applications.

Installation Notes

Application is typically performed by maintenance technicians, pipefitters, or HVAC service personnel as part of a surface preparation or corrosion control workflow. Remove loose scale, dirt, grease, and oil from the surface before applying; the converter requires direct contact with iron oxide to react properly. Apply using a brush, roller, or low-pressure sprayer and allow the full 24-hour dry time before recoating or painting. Work in a ventilated area and consult the product safety data sheet for PPE requirements consistent with OSHA guidelines.