Cooper Lighting LA56069301EWH-CA Led Gimbal Kit 5 6 Inch

Product Description

The COOPER LIGHTING LA56069301EWH-CA is a 5-inch and 6-inch LED adjustable gimbal retrofit kit designed for screw-base and dedicated LED recessed housings. The gimbal head tilts up to 35 degrees and rotates up to 360 degrees, allowing precise beam aiming in accent and task lighting applications. Output reaches up to 614 lumens at a 3000K color temperature with a 90 CRI rating, delivering warm, high-fidelity light. Rated for 35,000 hours of service life, this fixture operates at 120 volts with dimming capability down to 10 percent. It carries Air-Tite and ENERGY STAR certifications and is listed for damp and wet locations, including showers and protected ceilings.

This gimbal retrofit kit suits residential and light-commercial recessed lighting installations where directional light control is needed. Compatible with existing 5-inch and 6-inch screw-base and dedicated LED housings, it is a retrofit solution that eliminates the need to replace the housing. Typical applications include living rooms, kitchens, bathrooms, and covered outdoor areas. The wet location listing makes it suitable for shower ceiling installs where moisture exposure is a factor. This kit is approved for sale in California and meets applicable state energy standards. Sold in a package of 6 units.

Key Features

• 35-degree tilt and 360-degree rotation for full directional beam control
• Up to 614 lumens output at 3000K color temperature with 90 CRI
• Dims to 10 percent on compatible 120-volt dimmer circuits
• Rated for 35,000 hours of service life
• Damp and wet location listed — approved for showers and protected ceilings
• Air-Tite and ENERGY STAR certified for energy efficiency and air sealing
• California compliant — approved for sale and installation in CA

Compatibility

Designed for use in 5-inch and 6-inch screw-base and dedicated LED recessed housings. Fits existing retrofit installations without housing replacement.

Installation Notes

Installation should be performed by a licensed electrician in accordance with NEC requirements and local codes. De-energize the circuit at the breaker before removing the existing trim or lamp. Verify the existing housing size (5 inch or 6 inch) and type (screw-base or dedicated LED) before installing. For wet location applications such as showers, confirm the housing and junction box are rated for the installation environment.