Continental Contitech PLB03830-50-13 Air Hose 3/8 in

Product Description

The CONTINENTAL CONTITECH PLB03830-50-13 is a multipurpose PVC air hose rated for 300 psi working pressure and designed for general-purpose compressed air applications. Measuring 3/8 inch inside diameter and 50 feet in length, it covers a wide range of shop, field, and service-truck setups. The hose operates across a temperature range of -10 degrees F to 158 degrees F, making it viable in cold-weather startup conditions and warm shop environments alike. Male NPT fittings on both ends allow direct connection to standard air tools, compressors, and manifold ports without adapters in most cases. Licensed trades and general contractors reach for this hose wherever a reliable, flexible air supply line is needed at the point of use.

This hose is suited for residential and light commercial job sites, service vehicles, and workshop compressor drops. Common installation scenarios include HVAC service rigs, plumbing shops, and general mechanical bays where a mid-length air supply run is needed between a compressor outlet and a tool or blow-gun station. The 50-foot length reduces the need for extension fittings on most typical bay or van setups. Blue PVC construction keeps the hose lightweight and easy to coil and store between uses.

Key Features

• 300 psi working pressure rating for use with standard shop compressors
• 3/8 inch inside diameter delivers adequate flow volume for air tools and inflation tasks
• 50-foot length suits most service vehicle and workshop drop runs
• Operating range of -10 degrees F to 158 degrees F handles cold-start and warm-shop conditions
• MNPT x MNPT end connections fit standard compressor outlets and tool inlets directly
• Blue PVC construction is lightweight, flexible, and resistant to kinking under normal use

Compatibility

Designed as a general-purpose replacement or add-on air hose for use with standard 1/4 inch MNPT compressor fittings and air tool inlets commonly found in HVAC, plumbing, and mechanical service applications.

Installation Notes

Depressurize and disconnect the compressor from its power source before attaching or removing this hose. Thread MNPT fittings by hand first to confirm alignment, then tighten with a wrench using thread sealant tape on male threads to prevent leaks. Avoid sharp bends near the fittings, which can stress the hose end and cause premature failure. Inspect the hose for cuts, abrasions, or coupling looseness before each pressurization.