Continental Contitech 20042519 3V V-belt 112 in Hy-t Wedge

Product Description

The CONTINENTAL CONTITECH 20042519 is a 3V section V-belt constructed from fiber reinforced Wingprene rubber and built to the HY-T Wedge Matchmaker Envelope standard. With an outside length of 112 inches, this belt is engineered for reliable power transmission in demanding drive applications. The 3V cross-section profile delivers a high wedging action in the sheave groove, increasing load capacity while reducing belt slip. Licensed technicians and industrial maintenance professionals install this belt on motor-driven equipment where matched belt performance and dimensional consistency are critical to drive efficiency and service life.

This belt is suited for use in HVAC systems, fan drives, compressor drives, pumping equipment, and general industrial machinery where the 3V section is specified. It is a direct fit for drives requiring the 3V1120 belt designation. The HY-T Wedge Matchmaker Envelope style makes it appropriate for use in matched sets on multi-groove drives, where belt-to-belt length consistency is required to ensure even load sharing across all grooves.

Key Features

• 3V wedge section profile for high power transmission efficiency in narrow sheaves
• 112 inches outside length, designated belt number 3V1120
• Fiber reinforced Wingprene rubber construction for heat, oil, and flex resistance
• HY-T Wedge Matchmaker Envelope style for use in matched-set multi-groove drive applications
• Sold individually as a single belt unit

Compatibility

Designed as a direct replacement for drives requiring the 3V1120 belt designation. Suitable for any 3V section sheave drive specifying a 112 inch outside length belt.

Installation Notes

Installation should be performed by a qualified technician following applicable equipment manufacturer guidelines. Always de-energize and lockout/tagout the drive system before removing the old belt or seating the new one. Never pry or force the belt over sheave flanges; relieve tension by adjusting the motor or idler position before installation. After seating, set belt tension per the drive system specifications and re-check tension after the first few hours of operation.