Continental Contitech 20042008 V-belt Section a A83 85.2 in

Product Description

The CONTINENTAL CONTITECH 20042008 is a Section A V-belt constructed from Wingprene rubber-impregnated fabric, designed for power transmission applications in HVAC, industrial, and mechanical drive systems. With an outside length of 85.2 inches and an internal length of 84.30 inches, this belt carries the standard designation A83. It is built to perform across a wide temperature range, from -40 degrees C up to 140 degrees C, with resistance to both heat and oil. Licensed HVAC technicians, millwrights, and mechanical contractors install this type of belt during routine PM or equipment repair.

This belt fits standard fractional and integral horsepower drives using Section A sheaves. The HY-T Matchmaker style makes it suitable for use in matched-belt sets on multi-groove drives, as well as single-belt installations on motors, blowers, fans, and compressor drives common in commercial and residential HVAC equipment. It conforms to DIN 2215 and DIN 7753 standards, making it appropriate for both domestic and internationally spec'd equipment.

Key Features

• Wingprene rubber-impregnated fabric construction provides heat and oil resistance
• Operating range from -40 degrees C to 140 degrees C suits demanding environments
• HY-T Matchmaker style compatible with matched-set multi-belt drive applications
• Meets DIN 2215 and DIN 7753 standards for consistent dimensional accuracy
• Section A profile fits standard A-section sheaves and pulleys
• 85.2-inch outside length with A83 belt designation for straightforward cross-reference

Compatibility

Designed as an OEM-style replacement V-belt for Section A drive systems using standard A83 belts in HVAC, fan, blower, and light industrial power transmission applications.

Installation Notes

De-energize and lock out the equipment before removing the old belt or installing a new one. Do not pry or roll a V-belt onto a sheave with excessive force, as this can damage the belt cords. Check sheave alignment and groove condition before installation, and adjust drive tension according to the equipment manufacturer's specification. This work is typically performed by licensed HVAC technicians or qualified mechanical service personnel.