Continental Contitech 20041993 V-belt Section a 70.2 in A68

Product Description

The CONTINENTAL CONTITECH 20041993 is a Section A V-belt designed for power transmission applications in HVAC, industrial, and mechanical drive systems. Built from Wingprene rubber-impregnated fabric, this belt delivers reliable performance across a wide temperature range, from -40 degrees C to 140 degrees C. It carries the A68 belt designation, with a 70.2-inch outside length and a 69.30-inch internal length. This belt is rated heat resistant and oil resistant, making it a dependable choice for demanding service environments. Licensed HVAC technicians and mechanical service professionals are the primary installers.

This V-belt is suited for residential and light commercial HVAC equipment, blower assemblies, fan drives, compressor drives, and general-purpose power transmission setups where a Section A profile is specified. The HY-T Matchmaker style designation means it is compatible with standard A-section sheaves and pulleys. It conforms to DIN 2215 and DIN 7753 standards, making it appropriate for both domestic and international equipment applications requiring these specifications.

Key Features

• Section A V-belt profile for use with standard A-section sheaves and grooved pulleys
• Wingprene rubber-impregnated fabric construction for durability under heat and oil exposure
• Heat resistant and oil resistant ratings suitable for demanding drive environments
• Wide operating temperature range: -40 degrees C minimum to 140 degrees C maximum
• Meets DIN 2215 and DIN 7753 standards
• HY-T Matchmaker style for matched-set and single-belt drive applications

Compatibility

Designed as a direct replacement for Section A, A68-designation V-belts used in standard A-section sheave drive systems across HVAC, refrigeration, and general mechanical power transmission equipment.

Installation Notes

V-belt replacement is typically performed by HVAC technicians or mechanical service professionals. Disconnect and lock out all power to the unit before beginning any belt service. Loosen the motor mounting or idler pulley to relieve tension before removing the old belt, and seat the new belt fully into the sheave grooves before re-tensioning. Do not roll or pry the belt onto a pulley under tension, as this can damage the belt cords and reduce service life.