Continental Contitech 20039567 BX54 Cogged V-belt 57 in

Product Description

The CONTINENTAL CONTITECH 20039567 is a BX-section cogged V-belt designed for power transmission applications in HVAC, agricultural, industrial, and commercial equipment. Built with Fiber-Reinforced Vytracord construction, this Torque-Flex belt delivers reliable torque transfer under demanding load conditions. The cogged profile reduces bending resistance, allowing the belt to run cooler and seat deeper into sheave grooves compared to a standard wrapped belt. With an outside length of 57.0 inches and a belt number of BX54, it is a direct replacement for systems specifying that designation. Licensed technicians and millwrights handling drive system maintenance will find this belt dimensionally consistent with OEM specifications.

This belt is suited for use in residential and commercial HVAC blower drives, compressor drives, pump drives, and general industrial power transmission setups where a BX-section cogged belt is specified. The oil-resistant construction extends service life in environments where incidental oil contact is possible. It performs across a wide temperature range, making it appropriate for both indoor mechanical rooms and outdoor equipment installations where seasonal temperature swings are a factor.

Key Features

• Cogged BX-section profile reduces bending resistance and heat buildup during operation
• Fiber-Reinforced Vytracord construction provides high tensile strength and dimensional stability
• Oil-resistant compound extends belt life in environments with incidental oil exposure
• Wide operating temperature range: -40 degrees F to 140 degrees F (-40 C to 60 C)
• Torque-Flex design improves flexibility and efficiency on smaller-diameter sheaves
• Belt Number BX54 with 57.0-inch outside length and 55.80-inch internal length

Compatibility

Designed as an OEM-style replacement for drive systems specifying a BX54 cogged V-belt with a 57.0-inch outside length and BX belt section.

Installation Notes

Belt installation should be performed by a qualified technician. Always de-energize and lock out the equipment before removing or installing drive belts. Do not pry the belt over sheave flanges; adjust the drive center distance to allow the belt to seat properly without force. After installation, verify proper belt tension and sheave alignment before returning the equipment to service.