Continental Contitech 20026043 Push-on Air Hose 0.25 in Id

Product Description

The CONTINENTAL CONTITECH 20026043 is a push-on air hose designed for compressed-air distribution in shop, industrial, and trade service environments. Built from synthetic rubber with a green outer jacket, this hose carries a 250 psi working pressure rating and handles a temperature range of -20 degrees F to 190 degrees F. The 0.25 inch inside diameter suits standard push-on fittings without clamps or crimp ferrules. It is sold by the foot in cut-to-length increments, with a 25-foot minimum cut length from a 500-foot master coil. Plumbers, HVAC technicians, and general contractors install this type of hose for air-tool supply lines and pneumatic equipment connections.

This hose is suited for light to medium-duty compressed-air service in residential and commercial applications. Its push-on design accepts compatible 0.25 inch push-on fittings, making field assembly fast without specialized crimping equipment. The synthetic rubber construction resists ozone, weathering, and moderate abrasion. Typical installations include air compressor outlet runs, pneumatic tool drops, and shop air distribution headers where flexibility and quick-connect assembly are priorities. The cut-to-length format allows installers to size each run precisely without waste from fixed-length assemblies.

Key Features

• 250 psi working pressure for reliable compressed-air service
• Push-on design accepts standard push-on fittings without clamps or crimps
• Synthetic rubber construction resists ozone, abrasion, and weathering
• Temperature rated from -20 degrees F to 190 degrees F
• 0.51 inch outside diameter with 0.25 inch inside diameter
• Sold per foot in cut-to-length increments with 25-foot minimum cut

Compatibility

Designed for use with standard 0.25 inch push-on air fittings. No end connections are pre-installed; field fitting selection is required based on the specific tool or equipment inlet specification.

Installation Notes

Install and service compressed-air hose lines following applicable workplace safety standards and local mechanical codes. Depressurize the air supply completely before cutting, fitting, or replacing any hose section. Push-on fittings should be fully seated and inspected for retention before pressurizing the system. Do not exceed the rated working pressure of 250 psi at any point in the assembly.