Continental Contitech 20016585 Water Suction Discharge Hose

Product Description

The CONTINENTAL CONTITECH 20016585 is a synthetic rubber water suction and discharge hose rated for a maximum working pressure of 200 psi and a temperature range of -25 degrees F to 180 degrees F. Built for demanding fluid transfer applications, it handles both suction and discharge duty in a single assembly. The black synthetic rubber construction resists abrasion and weathering, making it a dependable choice for job sites, pump connections, and water handling systems. Licensed plumbers, irrigation contractors, and general contractors typically specify and install this hose where flexible, pressure-rated water conveyance is required.

This hose is suited for residential and commercial water transfer applications including pump intake and outlet connections, temporary site dewatering, and portable water supply runs. It is priced and cut in 1-foot increments with a 10-foot minimum cut length, allowing installers to order the exact footage needed for a specific run without surplus waste. Compatible fluid is water, making it appropriate for clean water service in plumbing, irrigation, and light industrial pump systems.

Key Features

• 200 psi maximum working pressure for reliable suction and discharge duty
• Temperature rated from -25 degrees F to 180 degrees F for seasonal outdoor use
• Synthetic rubber construction resists abrasion, weathering, and moderate flex fatigue
• Compatible with water service in plumbing, irrigation, and dewatering applications
• Sold in 1-foot increments with a 10-foot minimum cut length for job-specific ordering

Compatibility

Designed for water suction and discharge service. Compatible fluid is water. Consult system pressure and temperature ratings before installation to confirm fitment with the connected pump or piping assembly.

Installation Notes

Installation should be performed by a licensed plumber or qualified contractor familiar with hose assembly and pressure-rated connections. Depressurize and isolate the system before cutting or connecting the hose. Verify that all fittings, clamps, and end connections are rated to at least the hose working pressure of 200 psi. Do not exceed the rated temperature or pressure limits in service.