Continental Contitech 20012556 Lay Flat Water Hose 90 Psi

Product Description

The CONTINENTAL CONTITECH 20012556 is a lay flat hose designed for water transfer applications in irrigation, drainage, and general fluid-handling work. It collapses flat when not pressurized, making storage and transport straightforward on job sites. The hose handles a maximum working pressure of 90 psi and operates across a temperature range of -10 degrees F to 150 degrees F, making it suitable for use in cold-weather conditions as well as warm seasonal applications. Gray in color, it is priced and cut in 1-foot increments with a 25-foot minimum cut length. Licensed plumbers, irrigation contractors, and general trades commonly specify this hose for temporary or permanent water conveyance setups.

This lay flat hose is suited for residential and light commercial water transfer tasks including irrigation supply runs, dewatering, bypass lines, and portable pump discharge. Its lay flat profile allows it to be routed across flat surfaces with minimal tripping hazard compared to round-body hose. The hose is compatible with water as the working fluid. It is available in cut lengths starting at 25 feet, sold in 1-foot increments, making it easy to specify the exact run length needed for the job without excess waste.

Key Features

• Lay flat design collapses when depressurized for compact storage and routing on job sites
• 90 psi maximum working pressure suits standard pump and irrigation applications
• Wide operating temperature range of -10 degrees F to 150 degrees F supports year-round use
• Compatible with water for irrigation, drainage, and fluid transfer tasks
• Sold by the foot in 1-foot increments starting at a 25-foot minimum cut length
• Gray color for straightforward field identification

Compatibility

Designed for water transfer service and compatible with water as the working fluid. Suitable for use with standard lay flat hose fittings and pump discharge connections typically found in irrigation and dewatering applications.

Installation Notes

Installation is typically performed by irrigation contractors, plumbers, or general trades familiar with pump and hose systems. Relieve all system pressure and shut off the water source before making or breaking hose connections. Verify that all fittings and clamps are rated to meet or exceed the 90 psi working pressure of the hose. Do not exceed the stated temperature or pressure limits, and protect the hose from sharp edges or abrasive surfaces that could cause premature wear.