Comprehensive Connectivty Co. WP-HM2PT Hdmi Wall Plate

Product Description

The COMPREHENSIVE CONNECTIVTY CO. WP-HM2PT is a 2-port HDMI wall plate with pigtail connections, designed for clean, flush-mounted HDMI signal routing in commercial and residential AV installations. The pigtail design eliminates the need for keystone-style snap-in modules by providing pre-terminated HDMI leads on the back side of the plate, allowing direct connection to source cables without couplers. This wall plate is installed by AV integrators, low-voltage technicians, and electricians finishing structured wiring runs where a permanent, low-profile HDMI outlet is required at a wall station.

This wall plate is suited for conference rooms, classrooms, home theater setups, and any installation where two HDMI sources or displays need a dedicated wall-mounted termination point. The dual-port configuration supports two independent HDMI signal paths through a single standard single-gang wall plate opening, keeping cable runs organized and out of sight behind the wall surface.

Key Features

• Dual HDMI port configuration provides two independent signal paths in a single wall plate
• Pigtail lead design allows direct cable connection without additional couplers or adapters
• Flush-mount single-gang form factor fits standard electrical wall boxes
• Suitable for both residential and light commercial AV installations
• Clean front-facing HDMI ports keep signal connections accessible and organized

Compatibility

Designed as a standard replacement or new-installation wall plate for single-gang electrical boxes in residential and commercial low-voltage AV applications. No specific compatible model numbers were provided in the product data.

Installation Notes

Installation is typically performed by a licensed low-voltage technician or AV integrator. The wall plate mounts into a standard single-gang electrical or low-voltage bracket box. Route and connect the pigtail leads to the in-wall HDMI cable runs before securing the plate to the wall box. Verify all cable connections are fully seated before fastening the plate to avoid signal loss or connector damage.