Coilhose Pneumatics PE064-500Y Polyethylene Tube 500 Ft

Product Description

The COILHOSE PNEUMATICS PE064-500Y is a flexible polyethylene pneumatic tube rated for use in compressed air and fluid transfer applications. With a 0.25-inch inside diameter and a 0.375-inch outside diameter, this tube handles working pressures up to 120 psi across a wide temperature range of -40 to 150 degrees F. The 0.0625-inch wall provides a balance of flexibility and durability suited to industrial and shop environments. It ships as a 500-foot coil and is sold in 1-foot increments with a 25-foot minimum cut length. HVAC mechanics, plumbers, and pneumatics technicians commonly use this tubing for low-pressure distribution lines and instrument air runs.

This polyethylene tube is intended for use in compressed air distribution, pneumatic controls, and light fluid transfer in both commercial and light industrial settings. It is compatible with Coilock push-to-connect fittings and Poly-Tube fittings, making it easy to route and connect without specialized tooling. Its yellow color aids identification in multi-line installations. FDA and NSF-51 compliance makes it suitable for applications where incidental food-contact standards are required.

Key Features

• 120 psi maximum working pressure for standard pneumatic distribution
• Operating temperature range of -40 to 150 degrees F
• Shore 50D hardness — flexible yet kink-resistant
• FDA and NSF-51 compliant material
• Compatible with Coilock push-to-connect and Poly-Tube fittings
• Yellow color for easy line identification in multi-tube runs
• 500-foot coil sold in 1-foot increments, 25-foot minimum cut

Compatibility

Designed for use with Coilock push-to-connect fittings and Poly-Tube fittings. Suitable as a general-purpose polyethylene pneumatic tube in compressed air and light fluid transfer systems where 0.25-inch ID tubing is specified.

Installation Notes

Installation is typically performed by pneumatics technicians, HVAC controls mechanics, or plumbers working on compressed air or instrument air systems. Depressurize and lock out the supply line before cutting into an existing run. Use a clean, square tube cutter to avoid deformed ends that may leak at push-to-connect fittings. Consult applicable codes such as OSHA 29 CFR 1910.147 for lockout/tagout requirements before servicing pressurized lines.