Coilhose Pneumatics 600-FF12 Air Blow Gun 12 Inch 1/4 Npt

Product Description

The COILHOSE PNEUMATICS 600-FF12 is a safety flexible extension air blow gun designed for industrial and shop compressed-air applications. It features a thumb lever actuator, a 12-inch flexible extension tube, and a zinc body with a chrome-plated finish. The inlet accepts a standard 1/4 NPT female connection. Airflow is rated at 10.00 SCFM, and the decibel rating of 84 to 87 dB meets OSHA compliance standards for safety blow guns. The brass nozzle and zinc body offer corrosion resistance suited to demanding shop environments. Maintenance technicians, machine operators, and pneumatic system techs are the typical installers and users.

This blow gun is suited for general-purpose part blowoff, chip clearing, and debris removal in manufacturing, automotive, and maintenance shop settings. The flexible extension tube allows directional control in tight or hard-to-reach areas where a rigid nozzle would be impractical. Its OSHA-compliant design limits dead-end pressure, making it appropriate for workplaces subject to OSHA 29 CFR 1910.242(b) compressed-air safety requirements. The thumb lever provides controlled, one-handed operation during continuous-use tasks.

Key Features

• OSHA-compliant safety blow gun rated at 84 to 87 dB
• 12-inch flexible extension tube for directional reach in confined areas
• Thumb lever actuator for controlled, one-handed operation
• Zinc body with chrome-plated finish for corrosion resistance
• Brass nozzle for durability at the outlet tip
• 10.00 SCFM airflow rating at standard operating conditions

Compatibility

Designed as an OEM-style replacement or direct addition for compressed-air blow gun applications using a standard 1/4 NPT female inlet connection on regulated shop air systems.

Installation Notes

Installation is performed by maintenance technicians or pneumatic system personnel. Depressurize and disconnect the compressed-air supply line before attaching or removing the blow gun. Apply thread sealant tape to the 1/4 NPT male fitting on the air line before threading on the blow gun to prevent leaks. Verify system air pressure is regulated to a level consistent with the OSHA dead-end pressure requirement before placing the tool in service.