Cleveland C09762 Taper Length Drill Bit 17/32 in Hss

Product Description

The CLEVELAND C09762 is a taper length, straight-shank drill bit engineered for general-purpose drilling in ferrous and hard metals. Built from high-speed steel with a coated finish, it runs a 118-degree standard point angle and a web-thinned, tapered web configuration that reduces thrust during entry. The spiral flute geometry promotes chip evacuation across the full 9-inch flute length. At 12 inches overall length, this bit reaches deeper into workpieces than jobber-length alternatives while maintaining the rigidity needed for production and maintenance drilling environments. It is a right-hand cut tool intended for use in standard drill presses, lathes, and hand-held drilling equipment.

This drill bit is suited for drilling alloy tool steel, carbon steel, and cast iron in both shop and field settings. The Series 950E taper length format is commonly specified by machinists, millwrights, and maintenance mechanics when jobber-length bits lack the reach needed for deep-hole applications. The straight shank seats directly into standard drill chucks without adapters, keeping setup time low on the floor or in the field.

Key Features

• High-speed steel construction with coated finish for extended tool life in ferrous materials
• 118-degree standard point angle with web-thinned, tapered web for reduced entry thrust
• 9-inch spiral flute length promotes chip clearing in deep-hole drilling
• 12-inch overall length provides reach beyond standard jobber-length bits
• Right-hand cut, straight shank fits standard drill chucks without adapters
• Meets ASME B94.11M dimensional standards

Compatibility

Rated for drilling alloy tool steel, carbon steel, and cast iron. Compatible with standard drill chucks accepting a 17/32-inch straight shank. Designed as a general-purpose taper length replacement bit for Series 950E applications.

Installation Notes

Installation and use should be performed by machinists or qualified mechanical tradespeople familiar with drill press and rotating tool safety. Secure the workpiece fully before drilling and confirm chuck jaws are tightened on the straight shank before spindle engagement. Never exceed the spindle speed rating of the machine being used. Inspect the cutting edges and coating condition before each use and replace the bit if chipping or excessive wear is present.