Charlotte Pipe PVC-323-6IN Pvc Dwv 6 Inch Street Elbow

Product Description

The CHARLOTTE PIPE PVC-323-6IN is a 6-inch PVC DWV 1/8 bend street elbow (45 degrees) designed for drain, waste, and vent applications in non-pressure gravity-fed systems. This street configuration means one end accepts a plain pipe or fitting spigot directly, eliminating the need for an additional coupling in tight runs. Rated for service temperatures up to 140 degrees F, the fitting is manufactured from PVC, keeping installed weight low and simplifying handling in the field. It is a direct-application fitting suited for licensed plumbers and pipefitters working on residential or light commercial DWV rough-in.

This fitting is used in gravity-fed drain, waste, and vent systems where a 45-degree directional change is needed without a full sweep. Typical install scenarios include horizontal drain offsets, stack transitions, and branch connections in residential bathroom, kitchen, and laundry rough-in work. It is also appropriate for light commercial plumbing where PVC DWV piping is code-accepted. The fitting accepts solvent cement joining, which is the standard method for PVC DWV assemblies, and is also compatible with threading, flanging, and roll-grooved joining methods where applicable.

Key Features

• Street elbow configuration allows direct insertion into a fitting socket, reducing coupling count in tight spaces
• 45-degree (1/8 bend) angle suits horizontal drain offsets and stack transitions
• Rated for non-pressure, gravity-fed DWV service up to 140 degrees F
• Compatible with solvent cement, threaded, flanged, and roll-grooved joining methods
• Lightweight PVC construction requires no special cutting tools
• Manufactured in the USA by Charlotte Pipe

Compatibility

Designed as an OEM-style replacement and new-installation fitting for 6-inch PVC DWV piping systems operating under non-pressure, gravity-fed drain, waste, and vent conditions.

Installation Notes

Installation is performed by licensed plumbers following applicable IPC or local plumbing code requirements. Shut off water supply and verify the drain line is depressurized and dry before cutting into an existing system. When solvent cementing, use a PVC primer and cement rated for DWV fittings and allow full cure time per the cement manufacturer instructions before restoring flow. Do not use this fitting in pressure piping, hot water supply lines, or any application exceeding 140 degrees F.