Charlotte Pipe Pvc 07100 0200R Sch 40 Pvc Pipe 1-1/4x2

Product Description

The CHARLOTTE PIPE FOUNDRY CO. PVC 07100 0200R is a Schedule 40 PVC pipe section with a solid wall construction and plain ends, sized at 1-1/4 inches in diameter and 2 feet in length. Rated at 370 psi for cold water service, this pipe is manufactured to ASTM D1785 standards and carries NSF listing for potable water applications. It is a standard pressure-rated thermoplastic pipe used in residential and light commercial plumbing systems. Plumbers and pipefitters install this pipe for cold water supply runs, irrigation laterals, and general-purpose low-pressure piping where a rigid, corrosion-resistant solution is required.

This pipe section is suited for cold water distribution systems in residential, commercial, and industrial settings. It is commonly used in potable water supply lines, irrigation systems, and drain-waste-vent rough-in work where Schedule 40 wall thickness meets code requirements. Its plain-end configuration is designed for solvent-cement socket joints using standard PVC fittings. Each package contains 16 pieces, making this a practical restocking unit for plumbing contractors managing multi-fixture or multi-zone installations.

Key Features

• Schedule 40 solid wall construction rated at 370 psi cold water working pressure
• 1-1/4 inch nominal diameter, 2-foot length with plain ends for solvent-cement joining
• Manufactured to ASTM D1785 dimensional and pressure standards
• NSF listed for potable cold water service
• Corrosion-resistant PVC material suitable for a wide range of cold water plumbing applications
• Package quantity of 16 pieces per order unit

Compatibility

Designed for use with standard Schedule 40 PVC socket fittings and solvent-cement systems. Suitable for cold water plumbing applications conforming to ASTM D1785 and NSF requirements.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the International Plumbing Code (IPC) or applicable local codes. Shut off the water supply and depressurize the line before cutting into an existing system. Use a pipe cutter or fine-tooth saw to achieve a clean, square cut, then deburr and chamfer the pipe end before applying primer and solvent cement per manufacturer instructions. This pipe is rated for cold water service only and must not be used in hot water or pressurized steam applications.