Charlotte Pipe Pvc 02410 0500HA 1/2 in Pvc Cross Fitting

Product Description

The CHARLOTTE PIPE FOUNDRY CO. PVC 02410 0500HA is a 1/2-inch Schedule 40 PVC four-way cross fitting with a Slip x Slip x Slip x Slip (SxSxSxS) connection pattern. It provides two simultaneous horizontal branches off a vertical vent or waste line, making it a practical solution for split-line routing in low-pressure piping systems. Manufactured in white PVC, this fitting meets ASTM D 2466 requirements for Schedule 40 PVC fittings. Plumbers and irrigation installers use this fitting where a single vertical run must feed two lateral branches in the same plane without additional tees or adapters.

This cross fitting is suited for residential and light commercial applications including sprinkler and irrigation systems, as well as drain, waste, and vent (DWV) configurations where code and system design allow a four-way junction. The SxSxSxS end pattern accepts standard 1/2-inch PVC pipe with solvent cement on all four ports. It is sold in packages of 25 units, making it a practical stocking item for irrigation contractors and plumbing crews running multiple branch lines.

Key Features

• Four-way Slip x Slip x Slip x Slip connection accepts standard 1/2-inch PVC pipe on all ports
• Enables two simultaneous horizontal branches off a single vertical vent or waste line
• Meets ASTM D 2466 requirements for Schedule 40 PVC fittings
• White PVC construction resistant to corrosion and chemical degradation in typical plumbing and irrigation environments
• Packaged in quantities of 25 for jobsite and supply-house stocking efficiency

Compatibility

Designed for use in sprinkler and irrigation systems and compatible with standard 1/2-inch Schedule 40 PVC pipe joined with solvent cement. Suitable for DWV applications where a four-way cross configuration is permitted by local code.

Installation Notes

Installation should be performed by a licensed plumber or qualified irrigation technician in accordance with applicable local plumbing codes and ASTM D 2466 guidelines. Shut off all system pressure and drain the line before cutting into an existing run. Clean pipe ends and fitting sockets thoroughly, then apply an approved PVC primer and solvent cement per the cement manufacturer's instructions before making each slip connection. Do not apply heat or mechanical force to seat slip joints on PVC Schedule 40 fittings.