Charlotte Pipe Pvc 02302 1000HA 1 in 90 Deg Fpt Elbow

Product Description

The Charlotte Pipe Foundry Co. PVC 02302 1000HA is a 1-inch white PVC 90-degree elbow with female thread on both ends. It is designed to make a precise 90-degree directional change in a threaded pipe run. Built from PVC and meeting ASTM D 2466 requirements, this fitting delivers consistent dimensional accuracy and chemical resistance suited for low-pressure water service lines. Licensed plumbers and irrigation technicians install this fitting as part of buried or above-grade pipe systems where a right-angle turn is required at a threaded joint.

This elbow is used primarily in residential and commercial sprinkler and irrigation systems. The female-thread-by-female-thread configuration accepts male-threaded pipe or nipples on both ports, making it straightforward to position within a threaded piping layout. It is also appropriate for general-purpose cold-water plumbing applications where PVC schedule fittings conforming to ASTM D 2466 are specified. The fitting is sold individually and is available in package quantities of 50 units.

Key Features

• 90-degree turn geometry for right-angle direction changes in threaded pipe runs
• Female thread on both ends accepts standard male-threaded PVC pipe or nipples
• White PVC construction resists corrosion and common irrigation chemicals
• Meets ASTM D 2466 dimensional and pressure requirements for Schedule 40 PVC fittings
• 1-inch nominal pipe size fits standard 1-inch threaded piping systems

Compatibility

Designed as an ASTM D 2466 conforming Schedule 40 PVC threaded fitting for use in 1-inch sprinkler, irrigation, and cold-water plumbing systems.

Installation Notes

Installation is performed by licensed plumbers or irrigation technicians following applicable plumbing codes such as the IPC. Shut off the water supply and relieve system pressure before threading or unthreading any fitting. Apply an appropriate PTFE thread tape or pipe-thread sealant to all male threads before assembly. Do not use solvent-weld cement on threaded fittings and do not overtighten, as PVC threads can crack under excessive torque.