Charlotte Pipe Pvc 02300 1800HA 3 in Pvc 90 Degree Slip Elbow

Product Description

The CHARLOTTE PIPE FOUNDRY CO. PVC 02300 1800HA is a 3-inch white PVC 90-degree elbow with slip x slip connections, used to redirect flow at a right angle in a run of pipe. Manufactured to meet ASTM D 2466 standards, this fitting is built for reliable service in low-pressure piping applications. The slip x slip socket design accepts solvent-welded pipe connections on both ends, creating a clean, leak-resistant joint. Plumbers, irrigation contractors, and sprinkler system installers are the primary trades working with this fitting. It ships in a package of 10 units, making it practical for larger installations or service truck stocking.

This fitting is commonly installed in residential and light commercial sprinkler and irrigation systems where a 90-degree directional change is required. It is also used in general PVC drainage and low-pressure water distribution runs. The white color is standard for Schedule 40 PVC fittings in irrigation and above-ground plumbing applications. Contractors working on lawn irrigation layouts, agricultural irrigation headers, or ground-level distribution lines will find this fitting a direct fit for standard 3-inch PVC pipe.

Key Features

• 90-degree turn in a single fitting, eliminating the need for angled offsets
• Slip x slip socket ends accept solvent-weld connections on both sides
• Meets ASTM D 2466 requirements for PVC pressure fittings
• White PVC construction standard for Schedule 40 irrigation fittings
• Sold in packages of 10 for efficient jobsite supply

Compatibility

Designed for use in sprinkler and irrigation systems using standard 3-inch PVC pipe. Meets ASTM D 2466 requirements for PVC Schedule 40 pressure fittings.

Installation Notes

Installation is performed by plumbers or irrigation contractors following applicable plumbing and irrigation codes. Shut off the water supply and depressurize the line before cutting into existing pipe. Clean pipe ends and fitting sockets thoroughly, apply a compatible PVC primer and solvent cement per the cement manufacturer instructions, and allow full cure time before pressurizing the system. Do not use this fitting on systems exceeding the pressure rating of ASTM D 2466 Schedule 40 PVC fittings.