Charlotte Pipe Pvc 02116 1400HA 1-1/2 in Pvc Slip Cap

Product Description

The CHARLOTTE PIPE FOUNDRY CO. PVC 02116 1400HA is a 1-1/2 inch white PVC slip cap designed to close off the open end of a PVC pipe. This fitting creates a permanent, pressure-rated termination point by sliding over the pipe end and solvent-welding in place. It meets ASTM D 2466 requirements, confirming it is manufactured to a recognized standard for Schedule 40 PVC pressure fittings. Plumbers and irrigation technicians install this cap wherever a pipe run needs to be terminated cleanly, whether during system commissioning, seasonal winterization, or repair work on pressurized lines.

This cap is suited for use in residential and light commercial sprinkler and irrigation systems where PVC pressure piping is the standard material. It is equally applicable in potable water supply and general plumbing drain applications where a slip-style PVC cap of this pipe size is required. The slip connection accepts a 1-1/2 inch pipe OD and is joined using standard PVC primer and solvent cement per manufacturer and code requirements. This fitting is sold in packages of 25, making it practical for contractors stocking truck inventory or completing multi-zone irrigation projects.

Key Features

• Slip connection accepts 1-1/2 inch PVC pipe for solvent-weld installation
• Manufactured to ASTM D 2466 standard for Schedule 40 PVC pressure fittings
• White PVC construction for above-ground visibility and UV-resistant coloring typical of Schedule 40 fittings
• Caps off pipe ends in sprinkler, irrigation, and general plumbing applications
• Packaged in quantities of 25, suitable for contractor-level inventory

Compatibility

Designed as an ASTM D 2466-compliant slip cap for use with 1-1/2 inch Schedule 40 PVC pressure piping in sprinkler and irrigation systems.

Installation Notes

Installation is performed by licensed plumbers or qualified irrigation technicians. Shut off and depressurize the water supply before cutting into any live line. Clean and deburr the pipe end, apply PVC primer, then solvent cement per the fitting manufacturer instructions and applicable plumbing code requirements. Do not pressure-test the joint until the solvent cement has fully cured according to the cement manufacturer cure time chart.