Charlotte Pipe Pvc 02108 3200HA Pvc Reducer Bushing 2x1-1/2 in

Product Description

The CHARLOTTE PIPE FOUNDRY CO. PVC 02108 3200HA is a white PVC reducer bushing designed to step down pipe size from 2 inches to 1-1/2 inches. It features a spigot inlet and a female threaded outlet, allowing it to seat directly inside a fitting socket while accepting a threaded pipe or fitting on the downstream end. Manufactured to meet ASTM D 2466 requirements, this bushing is built for reliable service in low-pressure piping systems. Plumbers and irrigation technicians install this fitting wherever a pipe size reduction is needed in a PVC system. The package contains 10 bushings, sold as a unit of 10.

This reducer bushing is commonly used in residential and commercial sprinkler and irrigation systems where PVC Schedule 40 pipe transitions from a 2-inch main to a 1-1/2-inch branch or lateral line. It is equally suited to general plumbing drain, waste, and vent configurations that require a spigot-to-female-thread reduction. The white color is standard for Schedule 40 PVC fittings used in above-ground and underground irrigation layouts.

Key Features

• Reduces pipe size from 2 inches to 1-1/2 inches in a single fitting
• Spigot x female thread connection eliminates need for additional adapters
• Meets ASTM D 2466 requirements for PVC pressure fittings
• White PVC construction suitable for sprinkler and irrigation applications
• Packaged in quantities of 10 for job-site efficiency

Compatibility

Designed as an OEM-style replacement and standard fitting for 2-inch spigot x 1-1/2-inch female thread PVC Schedule 40 piping systems used in sprinkler and irrigation installations.

Installation Notes

Installation is performed by licensed plumbers or qualified irrigation technicians. Shut off system pressure and drain the line before cutting into existing piping. Clean and deburr pipe ends, then apply PVC primer and solvent cement per the fitting manufacturer instructions and applicable plumbing code requirements. For the threaded female outlet, use PTFE thread tape or an approved thread sealant on the male threads before making the connection; do not over-tighten, as PVC threads can crack under excessive torque.