Charlotte Pipe Pvc 02108 2000HA Reducer Bushing 1.5x1.25 in

Product Description

The Charlotte Pipe Foundry PVC 02108 2000HA is a white PVC reducer bushing with a spigot-by-thread (SPG x FPT) connection configuration. It steps a 1-1/2 inch pipe down to a 1-1/4 inch threaded fitting, allowing inline size reductions without cutting additional pipe sections. The bushing is manufactured to meet ASTM D 2466 standards, confirming material and dimensional compliance for pressure-rated PVC fittings. Plumbers, irrigation installers, and sprinkler system technicians use this fitting to transition between pipe sizes cleanly and efficiently. The white PVC construction resists corrosion and is compatible with standard Schedule 40 PVC solvent-weld and threaded systems.

This reducer bushing is suited for residential and commercial sprinkler and irrigation installations where pipe sizing changes occur at branch points, valve connections, or head assemblies. Its spigot end inserts directly into a standard 1-1/2 inch socket fitting, while the threaded female end accepts a 1-1/4 inch male-threaded pipe or fitting. Sold in packages of 25 units, this bushing is practical for contractors stocking fittings for multi-zone irrigation projects or routine service work.

Key Features

• Reduces 1-1/2 inch pipe to 1-1/4 inch threaded connection in a single fitting
• Spigot x Thread (SPG x FPT) end configuration for direct socket and threaded integration
• Meets ASTM D 2466 requirements for Schedule 40 PVC pressure fittings
• White PVC construction resists corrosion and chemical degradation in irrigation service
• Sold in 25-unit packages, suitable for multi-zone or bulk installation jobs

Compatibility

Designed as an OEM-style replacement or standard-stock fitting for Schedule 40 PVC sprinkler and irrigation piping systems requiring a 1-1/2 inch spigot to 1-1/4 inch female-threaded size reduction.

Installation Notes

Installation is performed by plumbers or irrigation technicians following local plumbing and irrigation codes. Depressurize and drain the system before disassembling any existing fittings. Apply appropriate PVC primer and solvent cement to the spigot end per ASTM D 2564 procedures; hand-tighten the threaded end with Teflon tape or approved thread sealant and avoid over-torquing the plastic threads. Do not use this fitting on systems exceeding the pressure rating established under ASTM D 2466 for the applicable pipe schedule.