Charlotte Pipe Pvc 00319 1200HA 4 in Dwv 60 Deg Sch 40 Elbow

Product Description

The CHARLOTTE PIPE FOUNDRY CO. PVC 00319 1200HA is a 4-inch Schedule 40 PVC DWV elbow configured at a 60-degree angle. It is designed for use in drain, waste, and vent piping systems where a moderate directional change is required. The Schedule 40 wall thickness provides the structural rigidity needed for both above-ground and in-wall installations. Licensed plumbers and pipefitters install this fitting as part of gravity-flow drain systems in residential and light commercial construction. This elbow ships in a package quantity of 10 units, making it practical for contractors running multiple rough-in lines on a single job.

This fitting is suited for DWV applications in residential and light commercial plumbing systems. The 60-degree angle addresses situations where a 45-degree elbow is too shallow and a 90-degree elbow creates too sharp a turn, helping maintain consistent drain flow and reducing the risk of buildup inside the line. Typical install scenarios include horizontal-to-horizontal transitions and branch connections in drain stack assemblies. Plumbers working on new construction, remodels, or drain-line repairs will find this fitting applicable across a wide range of common DWV configurations.

Key Features

• 60-degree sweep angle for moderate directional change in DWV drain lines
• Schedule 40 PVC wall construction meets standard DWV pressure and load requirements
• 4-inch diameter fits standard DWV drain and vent pipe of the same nominal size
• Sold in a package of 10 units, reducing per-fitting cost on multi-run jobs
• PVC material resists corrosion, chemical attack, and interior scaling from wastewater

Compatibility

Designed as an OEM-style replacement and new-installation fitting for 4-inch Schedule 40 PVC DWV piping systems in residential and light commercial plumbing applications.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the International Plumbing Code (IPC) and applicable local codes. Solvent-cement all joints using a PVC primer and PVC solvent cement rated for DWV service. Ensure the pipe and fitting socket are clean and dry before applying cement, and allow adequate cure time before pressurizing or flowing water through the line. Support horizontal runs at intervals specified by code to prevent sagging and maintain proper drain slope.