Charlotte Pipe Pvc 00303 0600HA Dwv Low Heel Inlet Elbow

Product Description

The CHARLOTTE PIPE FOUNDRY CO. PVC 00303 0600HA is a Schedule 40 PVC DWV Low Heel Inlet Elbow configured in a 3 inch x 3 inch x 1-1/2 inch hub-by-hub-by-hub pattern. This fitting is used to change flow direction in a drain, waste, and vent system while accepting a secondary branch connection at the low heel position. The 1-1/2 inch side inlet is a hub design, allowing direct connection to 1-1/2 inch pipe or a 1-1/2 inch fitting spigot. Licensed plumbers install this fitting in residential and commercial DWV rough-in work where a low-angle branch tie-in is required alongside a directional change.

This fitting is suited for drain, waste, and vent piping in residential and light commercial construction. The low heel inlet position allows a smaller branch line to tie into the main 3 inch run without requiring a separate wye or additional fittings. Typical applications include bathroom group drains, laundry connections, and similar scenarios where a 1-1/2 inch branch must merge into a 3 inch vertical or horizontal DWV stack. This fitting ships in a package quantity of 25 units.

Key Features

• Schedule 40 PVC construction for standard DWV service
• Three-port hub-by-hub-by-hub configuration: 3 inch x 3 inch x 1-1/2 inch
• Low heel inlet accepts 1-1/2 inch pipe or 1-1/2 inch fitting spigot directly
• Solvent-weld hub connections on all three ports for secure, leak-resistant joints
• Packaged 25 units per case for trade and contractor purchasing

Compatibility

Designed as an OEM-style replacement and new-construction fitting compatible with Schedule 40 PVC DWV pipe and fittings in 3 inch and 1-1/2 inch sizes per standard solvent-weld hub dimensions.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the International Plumbing Code and applicable local codes. Shut off all water supply and ensure the drain system is empty before cutting into an existing line. Use the appropriate PVC primer and solvent cement rated for DWV service on all hub connections, and allow full cure time before pressure-testing the system. Do not apply mechanical force to a freshly cemented joint.