Charlotte Pipe Foundry Pvc 00116 1200HA Dwv Cap 4 in

Product Description

The Charlotte Pipe Foundry Co. PVC 00116 1200HA is a 4-inch Schedule 40 PVC DWV cap designed for drain, waste, and vent piping systems. It installs via solvent weld, creating a permanent, leak-resistant closure at the end of a pipe run. This cap is made from Schedule 40 PVC, providing adequate wall thickness for residential and light commercial DWV applications. Licensed plumbers and qualified piping contractors install this fitting as part of rough-in and finish plumbing work where a clean, sealed pipe terminus is required.

This cap is used in residential and commercial drain, waste, and vent systems where a 4-inch PVC pipe end must be permanently capped. Typical applications include capping cleanout stubs, temporarily or permanently closing branch lines, and sealing test points during pressure testing of DWV assemblies. Its solvent-weld connection makes it well suited for concealed installations inside walls, floors, and underground runs.

Key Features

• Schedule 40 wall thickness suitable for standard DWV service
• Solvent weld connection for a permanent, leak-resistant seal
• 4-inch nominal pipe size fits standard DWV drain lines
• PVC construction resists corrosion and chemical degradation common in drain systems
• Package quantity of 5 units per package for multi-cap job requirements

Compatibility

Designed as an OEM-style replacement and standard fitting for 4-inch Schedule 40 PVC DWV piping systems in residential and commercial drain, waste, and vent applications.

Installation Notes

Installation should be performed by a licensed plumber following local plumbing codes and IPC guidelines. Before installation, shut off water supply and depressurize the affected line. Clean and dry the pipe end and fitting socket thoroughly, apply primer and solvent cement per manufacturer instructions, and allow adequate cure time before restoring flow or pressure. Do not use this fitting on pressurized supply lines.