Charlotte Pipe Abs 00401 0800HA Abs Dwv Sanitary Tee 2x1.5x2

Product Description

The CHARLOTTE PIPE FOUNDRY CO. ABS 00401 0800HA is a 2 x 1-1/2 x 2 inch ABS sanitary tee designed for drain, waste, and vent (DWV) piping systems. It features a Hub x Hub x Hub configuration, allowing a smaller 1-1/2 inch branch line to tap off a 2 inch main run. Manufactured from black ABS material, this fitting is rated for non-pressure DWV applications only. It is not intended for pressurized supply lines or high-chemical-exposure environments. Plumbers and pipefitters install this tee during rough-in of residential and light commercial drain and vent systems.

This sanitary tee is used in non-pressure drain, waste, and vent installations where a reduced branch connection is needed off a full-size main line. The 1-1/2 inch outlet accommodates common fixture branch lines such as lavatory drains, while the 2 inch run-through ports maintain the primary stack or horizontal drain line sizing. Typical applications include residential bathroom rough-in, laundry drain lines, and similar DWV configurations. This fitting is sold in a package quantity of 25 units.

Key Features

• 2 x 1-1/2 x 2 inch sanitary tee allows a smaller branch connection off a full-size main run
• Hub x Hub x Hub end connections for solvent-weld joining to ABS pipe
• ABS construction suited for non-pressure DWV service
• Black material finish standard for ABS DWV fittings
• Low chemical resistance rating — not suitable for aggressive chemical drain applications
• Sold in 25-piece package quantities

Compatibility

Designed as an OEM-style ABS DWV replacement or new-construction fitting for non-pressure drain, waste, and vent piping systems using solvent-weld hub connections.

Installation Notes

Installation is performed by licensed plumbers in accordance with the International Plumbing Code (IPC) or applicable local codes governing DWV piping. Before cutting into an existing drain line, ensure the system is taken out of service and the work area is clear of standing waste. Solvent-weld joints require approved ABS cement applied to both the pipe end and hub socket; allow full cure time before restoring flow. This fitting is rated for non-pressure DWV use only — do not install on pressurized supply lines.