Charlotte Pipe Abs 00300 1200HA 4 in 90 Deg Hxh Abs Dwv Elbow

Product Description

The CHARLOTTE PIPE FOUNDRY CO. ABS 00300 1200HA is a 4-inch, 90-degree hub x hub elbow fitting designed for ABS drain, waste, and vent (DWV) piping systems. It redirects piping flow by 90 degrees and uses solvent weld connections at both hubs for a secure, leak-resistant joint. Rated for a maximum working pressure of 5 psi, this fitting is intended strictly for non-pressure DWV applications. The black ABS construction offers durability for residential and light commercial drain and vent lines. Licensed plumbers and pipefitters are the primary installers of this component in new construction and retrofit DWV systems.

This elbow is used in DWV installations where the drain or vent line must change direction by 90 degrees. Typical applications include connecting horizontal drain runs to vertical stacks, routing waste lines around obstructions, and supporting air circulation within drainage piping. The hub x hub configuration accepts 4-inch ABS pipe at both ends. It is suited for removing wastewater from plumbing fixtures and for aiding air circulation in drainage piping, both standard functions in residential and commercial DWV systems. This fitting ships in a package quantity of 10 units.

Key Features

• 90-degree directional change for DWV drain and vent routing
• Hub x hub (1/4 bend) solvent weld connections on both ends
• ABS construction in black finish for DWV piping compatibility
• Rated to a maximum working pressure of 5 psi for non-pressure applications
• Supports wastewater removal and air circulation in drainage piping
• Do not use primer with ABS solvent weld installations

Compatibility

Designed for use with ABS DWV piping systems in non-pressure drain, waste, and vent applications. Accepts 4-inch ABS pipe at both hub ends using solvent weld cement.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and the International Plumbing Code (IPC). Shut off the water supply and ensure the drain line is empty and dry before cutting into existing piping. Use ABS solvent weld cement only — do not use primer with ABS fittings, as primer is not compatible with this material. Allow adequate cure time before restoring flow through the line.