Charlotte Pipe Abs 00116 1200HA Abs Dwv Hub Cap 4 in

Product Description

The CHARLOTTE PIPE FOUNDRY CO. ABS 00116 1200HA is a 4-inch ABS hub cap designed to close off the end of an ABS DWV pipe in non-pressure drain, waste, and vent systems. Made from black ABS plastic, this cap fits over the hub end of a pipe to provide a secure, leak-resistant termination point. It is a standard component in residential and light commercial rough-in plumbing and is installed by licensed plumbers or experienced pipefitters working with ABS DWV systems. The cap is rated for non-pressure applications only and offers low chemical resistance consistent with standard ABS material properties.

This hub cap is used in non-pressure drain, waste, and vent installations where a pipe end must be capped during rough-in, testing, or at a permanently terminated run. Typical applications include capping unused branch outlets, closing off stub-outs during construction, or terminating a DWV run that will not be extended. The part is sold in packages of 5 units, making it practical for jobs requiring multiple terminations. It is suited for residential construction, remodels, and light commercial plumbing projects.

Key Features

• 4-inch hub connection fits over standard ABS DWV pipe ends
• ABS plastic construction in black finish matches standard DWV piping
• Rated for non-pressure drain, waste, and vent service only
• Low chemical resistance appropriate for typical DWV waste streams
• Packaged in quantities of 5 for multi-cap job efficiency

Compatibility

Designed as an OEM-style replacement and standard fitting for non-pressure ABS DWV piping systems requiring a 4-inch hub cap termination.

Installation Notes

This cap is installed by licensed plumbers working on ABS DWV rough-in systems. Solvent-cement the hub cap onto the pipe end using ABS-approved cement per the manufacturer instructions and applicable plumbing code, typically IPC or local equivalent. Do not use this cap in pressure applications or with pipe materials other than ABS. Allow adequate cure time before pressure testing the system.