Charlotte Pipe Abs 00108 0800HA Abs Dwv Flush Bushing 2x1.5 in

Product Description

The CHARLOTTE PIPE FOUNDRY CO. ABS 00108 0800HA is an ABS DWV flush bushing designed to reduce pipe size from 2 inches to 1.5 inches in drain, waste, and vent piping systems. It features a spigot inlet and a female pipe thread (FPT) outlet, allowing it to connect directly into a fitting socket on one end while accepting a threaded pipe or fitting on the other. Molded from black ABS material, this bushing is rated for non-pressure DWV applications only. It is a standard component used by plumbers during rough-in work on residential and light commercial drain systems.

This flush bushing is used in non-pressure drain, waste, and vent installations where a 2-inch line must transition down to a 1.5-inch threaded connection. Typical scenarios include connecting branch drain lines, fixture traps, or vent tie-ins where a size reduction is required at a fitting hub. It is not intended for pressure piping, chemical drainage, or outdoor UV-exposed applications. The black ABS construction is compatible with standard ABS DWV pipe and fittings per applicable plumbing codes.

Key Features

• Reduces pipe size from 2 inches to 1.5 inches in a single fitting
• Spigot x FPT end configuration for direct hub and threaded connections
• Black ABS material suited for non-pressure DWV service
• Flush bushing profile seats cleanly inside a standard fitting socket
• Sold in packages of 50 units for trade and job-lot use

Compatibility

Designed as an OEM-style replacement and new-installation component for residential and light commercial ABS DWV piping systems requiring a 2-inch to 1.5-inch spigot-to-FPT reduction.

Installation Notes

Installation is performed by licensed plumbers in accordance with the International Plumbing Code (IPC) or applicable local plumbing codes governing ABS DWV systems. Ensure all drain lines are depressurized and dry before solvent-cementing or threading the bushing into place. Use ABS-rated solvent cement on the spigot end and apply thread sealant appropriate for ABS on the FPT connection. Do not use this fitting in pressurized water supply lines or in applications involving concentrated chemical drainage.