Charlotte Pipe Abs 00103 0800HA Abs Dwv Male Trap Adapter

Product Description

The Charlotte Pipe Foundry Co. ABS 00103 0800HA is a 1-1/2 inch ABS DWV male trap adapter designed to connect a drain line to a P-trap in non-pressure drain, waste, and vent systems. It features a spigot by slip joint thread configuration and is sold less washer and nut. The fitting is manufactured from black ABS material and is suited for residential and light commercial drain, waste, and vent installations. Plumbers and pipefitters install this adapter where a drain outlet transitions to a slip joint P-trap connection. Note that ABS material carries low chemical resistance, so confirm suitability for the specific waste stream before installation.

This adapter is used in non-pressure DWV applications such as sink drains, lavatory drains, and fixture rough-in work. The spigot end cements into a standard ABS DWV hub fitting or pipe, while the slip joint threaded end accepts a P-trap slip nut and washer assembly. It is a common component in kitchen and bathroom drain rough-ins where an ABS pipe stub-out must mate with a P-trap. This product is packaged in quantities of 50 units per package, making it practical for contractors working on multi-fixture projects.

Key Features

• 1-1/2 inch size fits standard residential DWV drain stub-outs
• Spigot by slip joint thread end configuration for direct P-trap connection
• ABS black material construction for non-pressure drain, waste, and vent service
• Sold less washer and nut — installer supplies slip joint hardware separately
• Packaged 50 units per package for contractor-quantity purchasing
• Low chemical resistance — confirm waste stream compatibility before use

Compatibility

Designed as an OEM-style ABS DWV fitting for non-pressure drain, waste, and vent piping systems using 1-1/2 inch ABS pipe and standard slip joint P-trap assemblies.

Installation Notes

Installation is performed by a licensed plumber in accordance with applicable local plumbing codes and the International Plumbing Code. Shut off the water supply and clear the drain line before beginning work. The spigot end is solvent-cemented into the receiving ABS hub using approved ABS cement and primer per manufacturer and code requirements. Do not use this fitting in pressure piping systems or in applications involving chemicals outside the rated resistance of ABS material.