Cerro Flow Products 1113 Type L Copper Pipe 2 in 10 Ft

Product Description

The CERRO FLOW PRODUCTS 1113 is a Type L copper pipe measuring 2 inches in diameter and 10 feet in length. Type L copper is a medium-wall pipe widely used in residential and light commercial plumbing systems for water supply, hydronic heating, and refrigeration line sets. Its wall thickness falls between the thinner Type M and the heavier Type K, making it suitable for a broad range of pressure-rated applications. Licensed plumbers and mechanical contractors install this pipe using standard sweat soldering, press-fit, or flare fittings. Manufactured in the United States, it meets the dimensional standards expected for professional plumbing and mechanical work.

Type L copper pipe in a 2-inch diameter and 10-foot length is commonly used for main water supply lines, larger domestic hot and cold water distribution runs, hydronic radiant and baseboard heating systems, and commercial plumbing rough-in. The 2-inch size is typical in building main lines and larger branch feeds where flow capacity is a primary consideration. This stick length is standard for above-ground and in-wall installation where full lengths can be managed on the job site.

Key Features

• Type L wall thickness rated for residential and light commercial water supply pressure applications
• 2-inch nominal diameter supports higher flow capacity in main and branch supply lines
• 10-foot stick length is a standard job-site size for above-ground plumbing runs
• Compatible with sweat solder, press-fit, and flare fittings in the 2-inch size class
• Manufactured in the United States

Compatibility

Designed as a standard Type L copper pipe replacement or new-installation material for 2-inch nominal plumbing and mechanical systems using copper-compatible fittings and joining methods.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the International Plumbing Code (IPC) and applicable local codes. Shut off and depressurize the water supply before cutting into any existing line. Use a pipe cutter sized for 2-inch copper and deburr all cut ends before fitting and joining. Avoid contact with incompatible metals in the same system without appropriate dielectric fittings to prevent galvanic corrosion.