Carrier DAMPSLS14X16 Slip-in Side Mount Damper 14x16

Product Description

The CARRIER DAMPSLS14X16 is a slip-in side mount zone damper designed for use in residential and light commercial HVAC duct systems. It measures 14 inches high by 16 inches wide and operates on a 24-volt AC control signal, making it compatible with standard low-voltage zoning controls and thermostats. The damper features a 15-second travel time from open to closed, allowing for smooth, controlled airflow modulation. Licensed HVAC technicians typically install this component as part of a multi-zone forced-air system to balance and direct conditioned air where it is needed.

This damper is suited for residential and light commercial forced-air zoning applications where precise airflow control is required. The slip-in design allows the unit to be inserted directly into a duct opening from the side, simplifying installation in both new construction and retrofit scenarios. It is commonly installed in rectangular supply or return duct runs as part of a zoning system managed by a zone controller or damper control board.

Key Features

• Slip-in side mount design for straightforward duct installation in new and retrofit systems
• 24-volt AC operation compatible with standard low-voltage HVAC zoning controls
• 15-second travel time for smooth, gradual airflow transitions
• 14-inch height by 16-inch width fits standard rectangular duct openings of that size
• Carrier and Bryant branded, suited for use in those system lineups

Compatibility

Designed for use in Carrier and Bryant forced-air HVAC zoning systems. Specific compatible equipment was not listed in the available product data. Verify duct dimensions and control voltage before installation.

Installation Notes

Installation should be performed by a licensed HVAC technician familiar with low-voltage zoning controls and ductwork. Power down the air handler and de-energize the zone controller before inserting or wiring the damper. Confirm the duct opening matches the 14-inch by 16-inch damper dimensions before install. Wiring should comply with applicable local mechanical and electrical codes.