Captiveaire LC1K0610G7 3-pole Contactor 6A 120V Motor Control

Product Description

The CAPTIVEAIRE LC1K0610G7 is a compact 3-pole TeSys K series contactor rated for motor control applications in light commercial and industrial electrical systems. It carries a 6-amp AC-3 rating at up to 440 volts and is driven by a 120-volt AC coil operating at 50 or 60 Hz. The unit includes one built-in normally open (NO) instantaneous auxiliary contact and uses screw clamp terminals for all connections. At 1.8 inches wide, it fits tightly in panel layouts and mounts on standard DIN rail or a plate. Licensed electricians and controls technicians are the primary installers. Motor power ratings reach 2.2 kW at 380 to 415 volts AC and 3 kW at 440 to 690 volts AC.

The LC1K0610G7 is suited for residential and light commercial motor control circuits where a compact, multi-standard-certified contactor is required. Typical applications include small HVAC fan motors, pump motors, and other AC induction motor loads up to 3 kW. The 120-volt coil makes it directly compatible with North American low-voltage control circuits. The device can be expanded with auxiliary contact blocks from the LA1K and LA2K series and paired with LR2K thermal overload relays for full motor starter assemblies.

Key Features

• 3-pole configuration with 3 normally open power contacts rated 6 A AC-3 at up to 440 volts
• 120-volt AC 50/60 Hz coil for direct compatibility with standard North American control circuits
• 1 NO built-in instantaneous auxiliary contact for control circuit feedback or interlocking
• Compact 1.8-inch-wide body supports DIN rail and panel plate mounting
• Mechanical durability rated at 10 million cycles; electrical durability rated at 1.3 million cycles at 6 A AC-3
• Multi-standard certified: UL, CSA, CE, UKCA, CCC, EAC, CB Scheme

Compatibility

Designed for motor control applications rated up to 3 kW at 440 to 690 volts AC. Compatible with LA1K and LA2K auxiliary contact blocks and LR2K thermal overload relays for expanded motor starter configurations.

Installation Notes

Installation should be performed by a licensed electrician in accordance with NEC requirements and applicable local codes. De-energize and lock out the control panel before mounting or wiring the contactor. Screw clamp terminals accept solid conductors from 1.5 to 4 mm squared and flexible conductors from 0.75 to 4 mm squared. Verify coil voltage matches the control circuit supply before energizing.