Campbell 6260203 Wire Rope Thimble Clip 3/8 in Steel

Product Description

The CAMPBELL 6260203 is a heavy-galvanized steel wire rope thimble clip designed to form a secure loop at the end of a wire rope assembly. The thimble fitting protects the rope eye from wear and crushing at the bend point, while the locking latch keeps the assembly from slipping under load. Built for 3/8-inch rope diameter, this clip is suited for rigging, lifting, and tie-down applications where a reliable, corrosion-resistant termination is required. Licensed riggers, marine contractors, and industrial maintenance crews use this type of hardware in both permanent and temporary rope terminations.

This thimble clip is used in wire rope rigging applications across construction, marine, agricultural, and general industrial settings. It is appropriate for use with 3/8-inch wire rope where a looped eye termination is needed. The heavy-galvanized finish provides corrosion resistance for outdoor and marine-adjacent environments. The locking latch design helps maintain clip position during assembly and inspection. It is sold individually and is compatible with standard 3/8-inch wire rope eye termination setups.

Key Features

• Fits 3/8-inch wire rope diameter
• Heavy-galvanized steel construction for corrosion resistance
• Locking latch type keeps clip positioned during assembly
• Thimble fitting protects rope eye from wear at the bend
• Clamp width of 2.125 inches accommodates standard rope loop geometry
• Loop inside width of 1.0625 inches for consistent eye formation

Compatibility

Designed as an OEM-style replacement and standard wire rope accessory for use with 3/8-inch diameter wire rope in looped eye termination assemblies.

Installation Notes

Installation is typically performed by licensed riggers or qualified maintenance personnel following applicable rigging standards. Always relieve tension from the wire rope assembly before installing or removing the thimble clip. Torque the clip fasteners per the manufacturer or applicable rigging code requirements using calibrated wrenches. Inspect the thimble and clip for deformation or corrosion before placing the assembly back into service.