Campbell 6050424 Welding Ring 1/4 in Wire Zinc Plated

Product Description

The CAMPBELL 6050424 is a welding ring designed for lifting, rigging, and load-securing applications in trade and industrial environments. Constructed from carbon steel with a zinc-plated finish, this ring accepts 1/4 inch wire and features a 1-1/2 inch inside diameter. It carries a working load limit of 450 pounds, making it suited for light to medium rigging tasks. Riggers, ironworkers, and general contractors use welding rings as terminal connection points in wire rope assemblies, chain rigging, and similar load-bearing configurations. The zinc finish provides basic corrosion resistance for indoor or sheltered outdoor use.

This welding ring is used in rigging assemblies where a fixed, welded connection point is required. Typical applications include wire rope terminations, block-and-tackle setups, and attachment points on hoists, fixtures, and structural anchorages. It is appropriate for light industrial, construction, and general maintenance applications where the load does not exceed the rated working load limit.

Key Features

• 1/4 inch wire size accommodates standard light-gauge wire rope and rigging hardware
• 1-1/2 inch inside diameter provides clearance for hooks, shackles, and connectors
• 450 pound working load limit rated for light to medium rigging use
• Carbon steel construction delivers strength appropriate to the load rating
• Zinc-plated finish resists surface oxidation in dry or sheltered environments

Compatibility

Designed as a standard welding ring for use in wire rope and rigging assemblies requiring a 1/4 inch wire size connection point with a 1-1/2 inch inside diameter.

Installation Notes

Welding rings are installed by qualified riggers or contractors familiar with applicable rigging standards and load calculations. Verify that the total system load, including dynamic forces, does not exceed the 450 pound working load limit before putting the assembly into service. Inspect the ring and all connected hardware for deformation, cracks, or corrosion prior to each use. Do not field-weld, modify, or heat-treat the ring after installation, as this may compromise its rated capacity.