Bsc Preferred QJDIB-MB-020 Masonry Drill Bit 1/4 Inch

Product Description

The BSC PREFERRED QJDIB-MB-020 is a 1/4-inch rotary percussion masonry drill bit designed for use in both rotary and hammer drills. The carbide tip delivers clean, accurate penetration into hard masonry substrates including brick, block, and concrete. An exact-point start geometry reduces walking at contact, allowing the bit to seat quickly and drill straight without pre-marking. At 0.06 pounds, this is a lightweight, single-use-class bit suited for everyday masonry work on the job site. Licensed tradespeople and experienced contractors reach for bits like this when setting anchors, running conduit through masonry walls, or drilling pilot holes in block foundations.

This bit is suited for residential and light commercial masonry applications where consistent, repeatable hole placement is required. It performs in standard rotary drills and SDS-compatible hammer drills when used with the appropriate chuck adapter. Typical installation scenarios include anchor setting in poured concrete, drilling through CMU block for sleeve anchors, and general-purpose masonry boring in renovation and new construction environments.

Key Features

• Carbide tip construction for extended wear life in abrasive masonry materials
• Exact-point start geometry reduces bit walking on contact
• Compatible with both rotary and hammer drill operation
• 1/4-inch diameter for standard anchor and fastener applications
• Lightweight at 0.06 pounds for easy single-hand handling

Compatibility

Designed as a standard 1/4-inch rotary percussion masonry bit compatible with rotary drills and hammer drills equipped with a standard keyed or keyless chuck.

Installation Notes

This bit is typically installed by general contractors, electricians, plumbers, and HVAC technicians when penetrating masonry substrates. Confirm the drill is set to hammer mode for best performance in concrete and block. Wear appropriate eye and respiratory protection when drilling masonry, as fine silica dust is generated. Do not use in SDS-only chucks without a proper reducing adapter.