Bsc Preferred QJDIB-MB-003 Masonry Drill Bit 1/4 Inch

Product Description

The BSC PREFERRED QJDIB-MB-003 is a carbide-tipped masonry drill bit designed for drilling through concrete, brick, and similar masonry materials. The carbide tip extends service life compared to standard steel bits, and the impact-ready construction allows use with both rotary hammer drills and standard hammer drills. A wide flute geometry promotes fast dust evacuation and heat dispersion during drilling, reducing bit wear and keeping the bore clean. This bit is suited for use by electricians, plumbers, HVAC technicians, and general contractors who regularly core through masonry for conduit, pipe, or equipment anchor points.

The QJDIB-MB-003 is sized at 1/4 inch, making it appropriate for light to medium masonry work such as anchor bolt pilot holes, conduit entry points through CMU or poured concrete walls, and brick facade penetrations. It is sold individually and fits standard SDS or keyed chuck configurations compatible with 1/4 inch shank tooling. Typical applications include residential and light commercial construction and renovation work where repeated masonry penetration is required.

Key Features

• Carbide tip for extended bit life in abrasive masonry materials
• Impact-ready design compatible with hammer drill operation
• Wide flute profile for efficient dust removal and heat dissipation during drilling
• 1/4 inch diameter suitable for anchor pilot holes and small conduit or pipe penetrations
• Sold as a single unit with a minimum order quantity of one

Compatibility

Designed as an OEM-style replacement or direct-use masonry drill bit for standard 1/4 inch chuck or SDS-compatible hammer drills used in concrete, brick, and block applications.

Installation Notes

Masonry drilling should be performed by qualified tradespeople following applicable OSHA and site safety requirements. Always wear eye protection and a dust respirator when drilling masonry. Begin drilling at low speed to seat the bit before applying full pressure, and allow the bit to cool periodically during extended use to preserve carbide tip integrity. Do not use in rotary-only mode on hard concrete without hammer action, as this will accelerate tip wear.