Bsc Preferred QJDIB-MB-002 Masonry Drill Bit 3/16 in

Product Description

The BSC PREFERRED QJDIB-MB-002 is a carbide-tipped masonry drill bit engineered for drilling into concrete, brick, block, and similar masonry substrates. The carbide tip extends service life compared to standard steel bits, and the impact-ready construction allows use with both rotary hammer drills and standard hammer drills. A wide flute design promotes rapid dust and debris evacuation from the hole, reducing heat buildup and keeping the bit cutting efficiently throughout the job. At 3/16 inch diameter, this bit is suited for anchor setting, fastener pilot holes, and general masonry penetration tasks encountered in commercial and residential fieldwork.

This bit is appropriate for use on residential and light commercial jobsites where concrete anchor installation, conduit strapping, bracket mounting, or similar fastener-based masonry work is required. Electricians, plumbers, and general contractors frequently reach for a 3/16 inch masonry bit when setting screw anchors or driving fasteners into poured concrete walls, CMU block, or fired brick. The impact-ready design makes it compatible with the rotary hammer and hammer drill settings common on tools used across trades.

Key Features

• Carbide tip for extended bit life in abrasive masonry materials
• Impact-ready construction compatible with rotary hammer and hammer drill modes
• Wide flute geometry for fast dust and debris removal during drilling
• Wide flute also aids heat dispersion, protecting tip integrity
• 3/16 inch diameter suited for anchor pilot holes and fastener penetrations

Compatibility

Designed as an OEM-style replacement or standard consumable masonry drill bit suitable for use with rotary hammer drills and hammer drills accepting standard straight-shank bits.

Installation Notes

Masonry drill bits are installed and used by licensed electricians, plumbers, HVAC technicians, and general contractors working to applicable building codes. Always wear eye protection and a dust mask when drilling masonry, as fine silica dust is generated. Use the hammer drill or rotary hammer setting on the drill; avoid using rotary-only mode in hard concrete, as this will damage the bit and reduce cutting efficiency. Keep the drill perpendicular to the work surface and allow the bit to clear the hole frequently to prevent debris buildup and overheating.