Bsc Preferred LTR6322101 Triple Bowl Drop-in Sink

Product Description

The BSC PREFERRED LTR6322101 is an 18-gauge Type 304 stainless steel triple bowl drop-in kitchen sink built for demanding residential and light commercial use. Three rectangular bowls, each measuring 19 inches in length, 16 inches in width, and 10 inches in depth, provide enough capacity for large sheet pans, stockpots, and heavy dish loads. The centered drain layout on each bowl simplifies plumbing rough-in and routine maintenance. Sound-deadening pads bonded to the underside reduce vibration and impact noise. A scratch-resistant lustrous finish maintains a uniform grain appearance under sustained use. Installation uses U-channel mounting clips, reducing the amount of under-sink access required during setup. This sink is manufactured in the USA.

The LTR6322101 is suited for kitchen installations in active households, rental properties, and light commercial prep areas where multiple simultaneous wash zones are needed. The drop-in configuration fits standard countertop cutouts and is compatible with laminate, solid surface, tile, and stone countertop materials. A minimum cabinet width of 66 inches is required. One faucet hole is required for installation. The sink can also serve laundry or utility room applications where multi-basin capacity is a priority.

Key Features

• 18-gauge Type 304 stainless steel construction for corrosion resistance and long service life
• Three extra-deep bowls at 10 inches deep each, suited for oversized cookware and baking sheets
• Centered drain placement on each bowl simplifies trap and drain line alignment
• U-channel mounting clips allow drop-in installation with minimal under-counter clearance required
• Sound-deadening undercoating reduces vibration and water-impact noise
• Scratch-resistant lustrous finish blends surface marks into the grain pattern over time
• Made in the USA

Compatibility

Designed as a drop-in replacement or new-installation sink for kitchens or utility areas requiring a triple bowl configuration. Requires a minimum cabinet width of 66 inches and one faucet hole.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and IPC guidelines. Shut off the water supply and disconnect existing drain lines before removing any existing sink. Verify countertop cutout dimensions and cabinet width meet the 66-inch minimum before setting the sink. Apply a continuous bead of silicone sealant around the cutout perimeter prior to dropping the sink into position, then secure using the supplied U-channel mounting clips from below.