Bsc Preferred LRAD332240MR2 Double Bowl Drop-in Sink

Product Description

The BSC PREFERRED LRAD332240MR2 is a double bowl drop-in kitchen sink constructed from 18-gauge Type 304 stainless steel. It measures 33 inches in length by 22 inches in width with a bowl depth of 4 inches. The two equal-sized rectangular bowls each measure 13.5 inches in length and 16 inches in width, providing dedicated zones for washing, soaking, rinsing, and drying. An offset drain design maximizes under-sink cabinet space, and both drains are positioned at the rear center of each bowl for improved usability. Sound-deadening pads are factory-applied to reduce vibration and noise during use. This sink is installed by licensed plumbers and general contractors working on residential kitchen remodels or new construction.

The LRAD332240MR2 is configured for MR2 faucet hole arrangements and requires a minimum base cabinet width of 36 inches for proper fit. The countertop cutout dimension is 32-3/8 inches x 21-3/8 inches with a corner radius of 1-1/2 inches. The U-channel mounting system accepts mounting clips within the channel perimeter, securing the sink to the countertop deck without specialized tooling. The ADA-compliant bowl depth supports accessibility requirements in residential and light commercial kitchens. This sink is manufactured in the USA and carries a satin finish that allows minor surface scratches to blend naturally with the brushed pattern over time.

Key Features

• 18-gauge Type 304 stainless steel construction for corrosion resistance and long service life
• Two equal rectangular bowls, each 13.5 inches x 16 inches, with rear center drain placement
• Offset drain configuration maximizes usable under-sink cabinet space
• Factory-applied sound-deadening pads reduce vibration and ambient noise
• U-channel mounting system with clip-in installation for straightforward drop-in fitting
• ADA-compliant bowl depth and MR2 faucet configuration pre-drilled at the factory
• Made in the USA with a satin finish that resists visible light scratching

Compatibility

Designed for drop-in installation in residential kitchen countertops with a minimum base cabinet width of 36 inches. Compatible with MR2 faucet configurations. Countertop cutout required: 32-3/8 inches x 21-3/8 inches with a 1-1/2 inch corner radius.

Installation Notes

Installation is performed by a licensed plumber following applicable IPC requirements. Shut off the water supply and disconnect existing drain plumbing before removal of any existing sink. Apply a continuous bead of silicone sealant around the countertop cutout perimeter before setting the sink, then secure mounting clips evenly within the U-channel to achieve a uniform seal. Do not overtighten clips, as this can distort the sink flange or crack stone countertop materials.