Bsc Preferred LRAD331960MR2 Dual Bowl Kitchen Sink

Product Description

The BSC PREFERRED LRAD331960MR2 is a drop-in, dual-bowl stainless steel kitchen sink built for residential and light commercial installations. Measuring 33 inches long by 19.5 inches wide by 6 inches deep, it features two equal-sized square bowls constructed from 18-gauge Type 304 stainless steel. A rear-center drain placement in each bowl frees up cabinet space below and simplifies trap routing. Sound guard padding and large sound-deadening pads bonded to the underside reduce operational noise. The lustrous grain finish is engineered for scratch resistance, and surface scratches can be restored without replacing the sink. Licensed plumbers and qualified kitchen installers are the typical trade for this fixture.

This sink is suited for drop-in installation in residential kitchens, prep areas, and laundry rooms. The dual-bowl configuration supports simultaneous washing, rinsing, and soaking tasks. A minimum cabinet width of 36 inches is required. The U-channel rim design allows mounting clips to be pre-positioned inside the rim before lowering the sink into the countertop cutout, reducing the need to work in the cabinet cavity during installation. The sink is ADA-compliant when installed at the correct countertop height per applicable accessibility standards.

Key Features

• 18-gauge Type 304 stainless steel construction for corrosion resistance and long service life
• Two equal-sized square bowls for versatile kitchen workflow
• Rear-center drain placement maximizes under-sink cabinet space
• Sound guard technology with large bonded pads for noise reduction during use
• Scratch-resistant lustrous grain finish with repairable surface
• U-channel rim with pre-placeable mounting clips for simplified drop-in installation
• ADA-compliant when installed at the correct height
• Made in the USA

Compatibility

Designed as a drop-in replacement or new installation sink for residential kitchens and prep areas requiring a 33-inch dual-bowl configuration with a minimum 36-inch base cabinet.

Installation Notes

Installation should be performed by a licensed plumber or qualified kitchen installer in accordance with local plumbing codes and IPC requirements. Shut off the water supply and disconnect existing drain and supply lines before beginning any sink swap. Verify countertop cutout dimensions match the sink specifications before cutting. Apply a continuous bead of silicone sealant around the perimeter of the cutout per the manufacturer instructions before seating the sink to prevent water infiltration.