Bsc Preferred LRAD2918651 Drop-in Kitchen Sink Dual Bowl

Product Description

The BSC PREFERRED LRAD2918651 is a drop-in, dual-bowl stainless steel kitchen sink designed for residential and light commercial kitchen installations. Built from 18-gauge Type 304 stainless steel, it measures 29 inches long by 18 inches wide by 6.5 inches deep and weighs 16 pounds. Each of the two equal-sized square bowls reaches 6.375 inches in depth, providing adequate capacity for washing large pots, sheet pans, and commercial cookware. A scratch-resistant, repairable finish resists daily wear, and factory-applied sound-deadening pads reduce basin vibration and noise during use. A single pre-punched faucet hole accommodates most standard deck-mount faucets. ADA compliance is achieved when the sink is installed to applicable code height requirements.

The LRAD2918651 is suited for residential kitchen remodels and new construction where a drop-in mounting method is specified. Its U-channel mounting clip system allows a single installer to secure the sink from below the countertop without specialty tools. A minimum cabinet width of 33 inches is required for proper fit. The 3.5-inch drain opening accepts standard kitchen basket strainers. The unit is manufactured in the USA and carries an ADA-compliant designation when installed per applicable guidelines, making it appropriate for accessible kitchen design projects handled by licensed plumbers or qualified contractors.

Key Features

• 18-gauge Type 304 stainless steel construction for corrosion resistance and long service life
• Two equal-sized square bowls, each 6.375 inches deep, for high-volume kitchen tasks
• Factory sound-deadening pads reduce vibration and basin noise
• Repairable, scratch-resistant lustrous finish blends surface marks over time
• U-channel mounting clips allow straightforward drop-in installation from below the deck
• ADA compliant when installed at required accessible counter height
• Made in the USA

Compatibility

Designed as a drop-in replacement or new-installation sink for residential and light commercial kitchen countertops requiring a 33-inch minimum cabinet width. Accepts standard 3.5-inch kitchen basket strainer drains and single-hole deck-mount faucets.

Installation Notes

Installation should be performed by a licensed plumber or qualified contractor in accordance with local plumbing codes and IPC requirements. Shut off the water supply and disconnect existing drain and supply lines before removing any existing sink. Apply a continuous bead of silicone sealant around the countertop cutout perimeter before seating the sink, then secure U-channel mounting clips evenly from below to prevent deck distortion. Verify finished counter height meets ADA requirements if accessible installation is specified.